D. Rear Panel Fans:
The Parts:
 |
Step 1
- Align the two 80mm case fans with the
screw holes on the inside of the case above the power supply.
- Secure the fans using the philips
screwdriver and case fan screws.
|
 |
Step 2
- Assemble the fan guards with philips
screwdriver and case fan screws
- These fans are installed
as exhaust fans
|
E. 7/12v Toggle Switch:
This is a miniature toggle switch, that connects to
the power supply with a 4 pin connector, has a 4 pin pass through, and you can
connect a 3 pin fan (or more with the use of 3 pin power splitters). This switch
allows you to easily toggle between 7 volts and 12 volts which significantly
reduces fan noise at the cost of some airflow.
 |
Step 1
- Custom 7/12v toggle switch manufactured by
Nerdsbyte
|
 |
Step 2
- Plunge cut hole in the front of the
plastic case panel with the Dremel tool and plunge cut tool
|
 |
Step 3
- Remove the retaining nut and washer from
the assembly
- Install the toggle switch from the rear of
the panel
- Secure the toggle switch with the washer
and retaining nut
|
 |
Step 4
- Pic of finished 7/12v assembly on plastic
front case panel
|
F. Drive Bay/ Hard Drive Cooler:
 |
Step 1
- Drive bay/ hard drive cooler assembly
|
 |
Step 2
- Slide drive bay cooler into the drive bay
|
 |
Step 3
- Mount the drive bay/ hard drive cooler to
the drive bay using the included mounting screws and philips screw driver
.
|
Next Page: It's Alive!
[Page 1]
[Page 2]
[Page 3]
[Page 4]
[Page 5]
[Page 6]
[Page 7]
[Page 8]
[Page 9] [Home]
