The Ultimate Case Project by The Tech Zone

C. Top Panel:

The Parts

	Step 1 Find and layout your center point for the compass using the diagram above. Setup the compass by measuring the inside diameter of the fan and half that measurement is what you use to set the protractor. Layout the hole using the compass.
	Step 2 Pic of top panel with finished layout with center point
	Step 3 Drill the starter hole for the jigsaw using the drill and 3/16" drill bit
	Step 4 I used masking tape to mask around the circle layout to avoid damaging the case paint Cut the blowhole along the circular pattern that was laid out above as indicated above Make sure you sand down all the rough edges of the blowhole and screw holes with the Dremel tool and sanding drum
	Step 5 Align the fan on the cut out blowhole Use the screw holes in the fan as a guide Drill the pilot holes in the four corners with the Dremel tool and the 1/8" drill bit Follow through the four pilot holes with the 3/16" drill bit and the drill
	Step 6 Make sure you remove the masking tape and sand down all the rough edges of the blowhole and screw holes with the Dremel tool and sanding drum Align the fan with the screw holes underneath and secure the fan and fan guards with philips screwdriver and fan screws.
	Step 7 Assemble the fan guard on fan on the under side of the top panel and fan using philips screwdriver and fan screws. This fan is installed as exhaust fan