The Ultimate Case Project by The Tech Zone

B. Side Panel:

These 92mm fans were strategically placed directly above the CPU and video card in order to maximize heat dissipation as exhaust fans.

The Parts

	Step 1 Find and layout your center point for the compass using the diagram above. Setup the compass by measuring the inside diameter of the fan and half that measurement is what you use to set the protractor. Layout the hole using the compass.
	Step 2 Pic of finished layout for both blowholes for 92mm fans.
	Step 3 Drill pilot/ starter holes for the jigsaw with the drill and 3/16" drill bit.
	Step 4 Cut the blowholes along the circles that you laid out above Make sure you sand down all the rough edges of the blowhole and screw holes with the Dremel tool and sanding drum
	Step 4 Align the fan on the cut out blowhole Use the screw holes in the fan as a guide Drill the pilot holes in the four corners with the Dremel tool and the 1/8" drill bit Follow through the four pilot holes with the 3/16" drill bit and the drill Make sure you sand down all the rough edges of the blowhole and screw holes with the Dremel tool and sanding drum Align the fan with the screw holes underneath and secure the fan and fan guards with philips screwdriver and fan screws. These fans are installed as exhaust fans