The Ultimate Case Project by The Tech Zone

A. Front Panel:

The Parts:

	Step 1 Find your center point for the compass using the diagram above. Setup the compass by measuring the inside diameter of the fan and half that measurement is what you use to set the protractor. Layout the hole using the compass.
	Step 2 The finished layout is ready to be cut
	Step 3 Carefully cut the hole following the circle layout with the jigsaw
	Step 3 Make sure you sand down all the rough edges of the blowhole and screw holes with the Dremel tool and sanding drum Align the fan on the cut out blowhole Use the screw holes in the fan as a guide Drill the pilot holes in the four corners with the Dremel tool and the 1/8" drill bit Follow through the four pilot holes with the 3/16" drill bit and the drill Make sure you sand down all the rough edges of the blowhole and screw holes with the Dremel tool and sanding drum Align the fan with the screw holes underneath and secure with philips screwdriver and fan screws.
	Step 4 Install the fan guard on the inside of the case using the fan screws and philips screwdriver
	Step 5 Pic of the finished front panel blowhole and fan assembly. This fan is installed as an intake fan